Aangemaakte reacties
-
Berichten
-
Ik kan u helpen met dat, geef me wat minuten.
Fouten niet meer aanwezig, maar deze wilt verwijderen, worden ze gegenereerd voordat apparaat wordt geprogrammeerd.
U2102: er zijn meer modules op kan mid snelheid dan op elke module worden geconfigureerd. Modules moeten weten wie er op het net, zodat ze correct kunnen met elkaar spreken. Controleer de Program Mid Speed Canbus in opcom.
B1023 is niet erg duidelijk in TIS2000. Niet zeker welke toets zit vast, enige oplossing in tis is om de radio te veranderen. :(
Check in Data List misschien kan je sommige toetsen niet werken.Probably that front panel pcb which contains the button must be replaced. I might have one for you, but must be checked if can be replaced and good working order.
If I am correct, you must do Program variant configuration. As far as I know, it cannot be done with opcom, but tech2 can. I have one.
I do not see why you could not fit cd70. Depends on which screen you go for, GID or CID, has to be programmed without ECC. That is done at program variant configuration. As far as I know, vectra c 2006 is full can bus, so the plug at cd70 should fit, about screen I do not know.
Plenty of pictures here, http://www.clubopel.com/viewtopic.php?t=66250″ onclick=”window.open(this.href);return false;
Heeft u alle benodigde onderdelen? Als ik u begeleiden hoe je dat doet, kun je het maken? Ik heb het gedaan op mijn Corsa C, ik heb Tech2 voor de programmering, niets anders werkt.
It seems that the code did not match with the one stored in the cd30 mp3. That is a bit strange, is this not the original cd30 mp3 of the car, maybe was latter fitted together with the display by a previous owner?
Of course there is the hardware solution, removal of EEPROM memory, read the hex file, reset the code to 0000 and put it in delivery mode. That’s a job for Pecky’s forum in UK.
Also Opcom is not good at reset, only tech2 is the best solution.
UHP4 goes on with CD30, CD30 MP3, CDC40 OPERA, CD70 NAVI, DVD90 NAVI, DVD100 NAVI and GID display or CID display with minimum software version 59 on Siemens VDO or with all Delphi-Grundig.
Price: new UHP4, 90 euro, original microphone 20 euro, 32 pin connector and some wiring 10 euro. Plus shipping from Europe.
7 wires to car connections to be done, 2 at the microphone, then programming with tech2 or mdi only. No other tester will work. Car pin code is needed for programming.
I did all above on my Corsa C and sound quality is good!
Hello there, if anybody needs oem tech2 original, gratis for diagnosis, PM me. I am living in Capelle aan den IJssel. I limit myself to reading codes, clearing codes, programming as far as I know, if you know more, I have the tool.
Regards,
LiviuI can understand a bit, use a lot google translate but writing is a different story … :) It should not matter, I will try to put my expertise and oem tech2 (for free) at work here. Thanks for the welcome.
As far as I know, there is no oil temperature sensor on your car. Neither a location for it, unless you drill into the oil bath with some kind of adaptor.
